产品名称：IEC61032 IP3X Test Probe C试验指针销厂家

IEC61032 IP3X Test Probe C试验指针销厂家

本试棒是用于检验防止人体触及危险部件的试具。此试具也有用于防止手持工具触及的防护检验。

1.根据GB/T4208-2008、IEC61032:1997、IEC60529:2001及UL等相应条款制作而成。

2.C类试验探棒（C类试验针）是进行家用和类似用途电器防触电保护试验的必备器具。

技术参数：

1、探棒长度：100mm

2、探棒直径：2.5mm

3、档球直径：35mm

4、手柄直径：10mm

5、手柄长度：100mm

6、根据IEC61032图3(Test probe C) 、GB/T4208-2008表6（一位特征数字3）。

三、使用方法：如图所示，标准试验指的关节部分不能触及带电部件或不能接近危险部件，并且35mm的圆挡板不能进入。

防止接近危险部件的试验要求中，C、D型试验探棒需带3±0.3N N或1±0.1N推力。

注意：不带推力产品请配合推拉力计使用。

IEC61032 IP3X Test Probe C试验指针销厂家

IEC61032 IP3X Test Probe C (Test Probe C)

Article NO.:BND-C

Basic Introduction:

1, According to: IEC61032:1997/IEC60529:2001 AND UL

2, IP3X Test Probe C ( Test Probe C)  is the necessary tool to proceed protecting electric shock test of household and similar electrical appliances.

IEC61032 IP3X Test Probe C试验指针销厂家

Technical parameters

1,  Test Probe Length :100mm

2,  Test Probe Diameter:2.5mm

3,  Dam- sphere Diameter:35mm

4,  Handle Diameter:10mm

5,  Handle Length 100mm

6,  According to IEC61032 figure 3 (the Test probe C), table 6 

IEC61032 IP3X Test Probe C试验指针销厂家 

Application:

1,  Standard test refers to the joint part can't touch the live parts or close to the dangerous parts, and 35mm circular baffle can not be enter .

2,  In the test requirement for preventing access to the hazardous parts,  Test Probe C/D need to be with push force 3±0.3N or 1±0.1N

Purpose:

This probe is intended to verify the basic protection against access to hazardous parts. It's also used to verify the protection against access with a tool.

Note:For the without force products,please use with the dynamometer.

IEC61032 IP3X Test Probe C试验指针销厂家